Zanussi ZR 290/3TN Instruction Booklet page 7

Press in the joint covers between the appliance and
the kitchen unit.
Apply covers (B) on joint cover lugs and into hinge
holes.
Position the runners (E) at the top and bottom of the
inside of the kitchen unit as shown in Fig. 8 and mark
the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
Open both the appliance door and that of the kitchen
unit to approx. 90 .
Place the little plates over the runners. Hold the doors
of the appliance and the unit together and mark the
holes.
D030
B B
D013
E
D285
8mm
PR34
Fig. 6
Fig. 7
Fig. 8
Fig. 9
19