Installation - Zanussi ZF67/35E Instructions For The Use And Care

Hide thumbs Also See for ZF67/35E:
Table of Contents

Advertisement

Installation
Warning
If you are discarding an old appliance
that has a lock or catch on the door,
please ensure that this is made unusable
to prevent young children getting trapped
inside.
Electricity Supply
The appliance is for operation on a
220/240 V. 50 Hz supply, so be sure that
your electricity supply voltage is within
this range which is also marked on the
nameplate located inside the cabinet.
Earthing
WARNING: THIS APPLIANCE MUST
BE EARTHED. The manufacturer
declines any liability should this safety
measure not be observed.
If the plug that is fitted to your appliance
is not suitable for your socket outlet, it
must be cut off and the appropriate plug
fitted.
The cut off plug should be disposed of to
prevent the hazard of electric shocks in
case it should be plugged into a 13 Amp
socket in another part of your home.
Electrical connection
IMPORTANT: The wires in this mains
lead are coloured in accordance with the
following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth) wire
to the terminal in the plug which is
marked with the letter "E" or the earth
symbol fy , or coloured green, or green
and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter "N" or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
"L" or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement use
a 13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced in
the event of changing fuse.
The right fuse cover/carrier colour is the
one shown by the coloured insert at the
base of the plug or is the colour of the
inscription at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost.
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed on the
attached ''Zanussi Service and Spares
Nationwide".
THIS APPLIANCE COMPLIES WITH
E.E.C. DIRECTIVE NO. 82/499 OF
7.6.82 RELATIVE TO RADIO
INTERFERENCE SUPPRESSION.
3

Advertisement

Table of Contents
loading

Table of Contents