Fitting The Hob Into The Worktop - Zanussi ZGS 682 I Instruction Booklet

Fitting the Hob into the
Worktop
Carry out the building in of the hob as
follows:
1. place the seals supplied with
the hob on the front edge of the
cut out. Then, place them at 11
mm from the side edges and at
10 mm from the rear edge, as
shown in the diagram, taking
care that the seals meet without
overlapping.
2. place the hob in the cut out,
taking care that it is centred;
3. fix the hob with the relevant
fixing clamps and screws, as
shown in the diagram. When the
screws have been tightened,
the excess seal can be
removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
20
Seal