Table of Contents
Advertisement
Electrical connections
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person,
in accordance with the current regulations.
THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This appliance is designed to be connected
to a 230 V 50Hz AC electrical supply.
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load (see the rating label);
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit. Before
switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate. The rating plate is located on the bottom
of the hob. A copy is attached on the back cover of
this book.
The appliance is supplied with a 3 core flexible
supply cord incorporating a plug. Connect the plug to
an adequate socket.
Permanent Connection
In the case of a permanent connection, it is necessary
that you install a double pole switch between the
appliance and the electricity supply (mains), with a
minimum gap of 3 mm. between the switch contacts
and of a type suitable for the required load in
compliance with the current electric regulations.
The switch must not break the yellow and green earth
cable at any point.
Ensure that the hob supply cord does not
come into contact with surfaces with
temperatures higher than 50 deg. C.
13
Advertisement
Table of Contents
