Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Main power switch
SUB-POWER button
STANDBY/ON
button
18
Indicating lamp
STANDBY/ON
RECALL
TV DVD
+
/I
i
AV 1
AV 2
AV 3
AV 4
AV 5
AV 6
RGB 1
RGB 2
1
2
3
4
5
6
7
8
9
0
2-4-12
MENU
RETURN
OK
A. MODE
P. MODE
VOL
PROG
+
+
P
I/II
P
?
i
Turning Power On and Off
• To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press
the SUB POWER button of control panel or the
STANDBY/ON button on the remote control.
• To turn the monitor power off, press the SUB POWER
button of control panel or the STANDBY/ON button on
the remote control, and then press the main power
switch on the monitor main unit to OFF.
• During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the STANDBY/ON button on the remote
control.
Indicating lamp
Indicating
Power status
lamp
Off
Off
Off
Lights red
(standby)
Lights green
On
Off
Lights orange
(Power Save)
When the indicating lamp lights in orange or the message "No Sync.
Signal", "Power Save" or "Invalid Scan Freq." appears on the
screen, there is something unusual about the status of reception.
See "Power Save Mode" or "Symptoms That Seemingly Appear to
be Failures."
41 42
43
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
• If a power failure occurs whilst the main unit is running, it wouild
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaveing the main unit.
Operating
When the main power switch is set
to OFF.
When the main power switch is
ON, and the STANDBY/ON button
on the remote control or the SUB
POWER button on the underside of
the front of the frame is OFF.
When the main power switch is
ON, and the STANDBY/ONbutton
on the remote control or the SUB
POWER button on the underside of
the front of the frame is ON.
When the main power switch is
ON, and the STANDBY/ON button
on the remote control or the SUB
POWER button on the underside of
the front of the frame is ON.
However, the state is in POWER
SAVE mode.
Advertisement
Table of Contents
