Input Menu - Yamaha RX-V359 Owner's Manual

Dynamic range
4 D.RANGE
Use this feature to select the amount of dynamic range
compression to be applied to your speakers or
headphones. This setting is effective only when the unit is
decoding Dolby Digital and DTS signals.
Choices: MIN (minimum), STD (standard), MAX
(maximum)
Speaker SP D.R
Adjusts the speaker compression.
Headphone HP D.R
Adjusts the headphone compression.
• Select "MIN" if you regularly listen at low volume
levels.
• Select "STD" for general use.
• Select "MAX" to preserve the greatest amount of
dynamic range.
Tone bypass 5 TC.BYPASS
Use this feature to select whether audio output bypasses
tone control circuitry when "BASS" and "TREBLE" are
set to 0 dB (see page 24).
Choices: AUTO, OFF
• Select "AUTO" if you want signals to bypass tone
control circuitry to provide the purest signal possible.
• Select "OFF" if you do not want signals to bypass tone
control circuitry.

INPUT MENU

Use this menu to reassign input jacks or select the input
mode.
Input assignment
Use this feature to assign the input jacks according to the
component to be used if the initial settings of this unit do
not correspond to your needs. Change the following
parameters to reassign the respective jacks and effectively
connect more components.
Once the input jacks are reassigned, you can select the
corresponding component by using INPUT l / h on the
front panel (or the input selector buttons on the remote
control).
For COMPONENT VIDEO jacks [A][B][C]
Choices: [A] DVD, DTV/CBL, VCR, V-AUX
[B] DVD, DTV/CBL, VCR, V-AUX
[C] DVD, DTV/CBL, VCR, V-AUX
For OPTICAL INPUT jacks 1 2
Choices: (1) DVD, DTV/CBL, CD, VCR, MD/CD-R,
V-AUX
(2) DVD, DTV/CBL, CD, VCR, MD/CD-R,
V-AUX
For COAXIAL INPUT jack 3
Choices: (3) DVD, DTV/CBL, CD, VCR, MD/CD-R,
V-AUX
Notes
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the signals input at the
COAXIAL jack.
Input mode 2 INPUT MODE
Use this feature to designate the input mode for sources
connected to the DIGITAL INPUT jacks when you turn on
this unit (see page 26).
Choices: AUTO, LAST
• Select "AUTO" to allow this unit to automatically
detect the type of input signal and select the
appropriate input mode.
• Select "LAST" to set this unit to automatically select
the last input mode used for that source.
SET MENU
1 INPUT ASSIGN
47