Playing The Keyboard - Yamaha AVANT GRAND N1 Owner's Manual

1
Connecting the power cord
1-1 Set the voltage selector and insert the power cord plug to the [AC IN] connector. Refer to the "Panel Con-
trols and Terminals" on page 8 for information on the location of the [AC IN] connector.
[AC IN]
connector
Voltage Selector
Before connecting the AC power cord, check the setting of the voltage selector which is provided
in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus"
screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the
pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the
proper voltage has been selected, connect the AC power cord to the AC IN and an AC wall outlet.
A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall
outlets in your area.
WARNING
Make sure your instrument is rated for the AC voltage supplied in the area in which it is to be used. (The voltage rating
appears on the name plate on the bottom panel). Connecting the unit to an inappropriate AC supply can seriously
damage the internal circuitry and may even pose a shock hazard!
1-2 Insert the plug on the other end of the power cord to a standard AC outlet.
WARNING
Use only the AC power cord supplied with the instrument. If the supplied power
cord is lost or damaged and needs to be replaced, contact your Yamaha dealer.
The use of an inappropriate replacement can pose a fire and shock hazard!
WARNING
The type of AC power cord provided with the instrument may be different depend-
ing on the country in which the instrument was purchased. (In some areas a plug
adaptor may be provided to match the pin configuration of the AC wall outlets in
your area.) Do NOT modify the plug provided with the instrument. If the plug will
not fit the outlet, have a proper outlet installed by a qualified electrician.
2
Opening the fallboard
Using the hand grip on the front, lift open the fallboard.
CAUTION
Hold the fallboard with both hands when opening or closing it.
Do not release it until it is fully opened or closed. Be careful to
avoid catching fingers (yours or others, especially children's)
between the fallboard and the unit.
CAUTION
Do not place objects such as a piece of metal or paper on top
of the fallboard. Small objects placed on the fallboard may fall
inside the unit when the fallboard is opened and may be nearly
impossible to remove. This could cause electric shock, short
circuit, fire or other serious damage to the instrument.
If this happens, turn off the power immediately and unplug the
power cord from the AC outlet. Then have the instrument
inspected by qualified Yamaha service personnel.

Playing the Keyboard

Voltage
Selector
For models that feature a voltage selector:
Set the voltage selector to an appropriate voltage.
(The shape of the plug differs
depending on locale.)
CAUTION
Be careful to avoid catching your
fingers when opening the fallboard.
N1 • 9
Owner's Manual