Yamaha AR210 Owner's/Operator's Manual page 32

2
F
EATURES
WARNING
Always attach the engine shut-off
cord to your personal flotation
device (PFD) BEFORE starting
the engine. Failure to attach the
cord could result in a runaway
boat if the operator is ejected.
Do not attach the cord to clothing
that could tear loose. Do not route
the cord in such a way that it
could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the
cord during normal operation.
Once the engine has stopped you
have no steering control of the
boat which could result in an
accident. Also, without engine
power, the boat could slow rapid-
ly from planing speed. This could
cause people and objects in the
boat to be thrown forward, which
could cause injury.
MAIN SWITCHES
There is a main switch for each engine.
The main switches control the ignition
and electrical circuits as follows:
1
2
1 Port (left) engine
2 Starboard (right) engine
& F
UNCTIONS
OFF:
Ignition circuits are switched off. The
engine cannot be started but other
switches will operate. (The key can be
removed.)
ON:
Ignition circuits are switched on. (The
key cannot be removed).
START:
The starter motor will turn to start the
engine. (When the key is released, it
returns automatically to "ON.")
NOTE: The engine will not start when
the engine shut-off cord clip is removed
from the engine stop switch. The starter
motor will turn over without the cord
attached.
THROTTLE LEVERS
3
1
2
1 Throttle lever, port (left) engine
2 Throttle lever, starboard (right) engine
3 Idle
4 Full speed
WARNING
Before starting the engine, always
check the operation of each throttle
lever. It should move smoothly
through its full range of operation.
Otherwise, there could be loss of
control and an accident.
2-6
4