Front Wheel - Yamaha VMAX VMX12S Owner's Manual

1. Turn signal light bulb
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
CAUTION:
Do not overtighten the screws, oth-
erwise the lens may break.
PERIODIC MAINTENANCE AND MINOR REPAIR

Front wheel

To remove the front wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Place the motorcycle on the cen-
terstand.
2. Disconnect the speedometer ca-
ble from the front wheel.
3. Remove the brake calipers by re-
moving the bolts.
CAUTION:
ECA10680
Do not pull the brake lever after the
brake caliper has been removed,
otherwise the brake pads will be
forced shut.
4. Loosen the front wheel axle pinch
bolt, then the wheel axle.
EAU24360
EAU24430
EWA10820
1. Speedometer cable
2. Bolt
3. Front wheel axle pinch bolt
4. Wheel axle
5. Pull the wheel axle out, and then
To install the front wheel
ECA11060
1. Install the speedometer gear unit
6-36
remove the wheel.
into the wheel hub so that the pro-
jections mesh with the slots.
6
EAU24842