Yamaha VMAX VMX12S Owner's Manual page 20

INSTRUMENT AND CONTROL FUNCTIONS
Dimmer switch "LIGHTS"
Set the switch to "HI" for the high beam
and to "LO" for the low beam.
Turn signal switch "TURN"
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
3
turn, push the switch to the left. When
released, the switch returns to the cen-
ter position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
NOTE:
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
while you are stopped at an intersec-
tion.
EAU12410
Horn switch "HORN"
Press this switch to sound the horn.
Engine stop switch "ENGINE STOP"
EAU12420
Set this switch to "RUN" before starting
the engine. Set this switch to "OFF" to
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "START"
Push this switch to crank the engine
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
Fuel reserve switch "FUEL"
During normal operation, this switch
should be kept in the "ON" position. If
the fuel warning light comes on while
riding, set the switch to "RES", refuel as
soon as possible, and then set the
switch back to "ON".
EAU12510
NOTE:
After switching to "RES", approximately
3.0 L (0.79 us.gal) (0.66 imp.gal) of fuel
EAU12650 remain in the fuel tank.
EAU12690
ECA10050
EAU12790
3-4