Final Transmission Oil - Yamaha VINO YJ50RP Owner's Manual

1
1. Final transmission oil filler cap
2. Final transmission drain bolt

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final trans-
mission oil must be changed as fol-
lows at the intervals specified in the
periodic maintenance and lubrication
chart.
1. Start the engine, warm it up by
riding the scooter for several
minutes, and then stop the
engine.
PERIODIC MAINTENANCE AND MINOR REPAIR
2. Place the scooter on the center-
stand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
4. Remove the oil filler cap and
drain bolt to drain the oil from the
final transmission case.
2
5. Install the final transmission oil
drain bolt, and then tighten it to
the specified torque.
EAU04228
Tightening torque:
Final transmission oil drain bolt:
18 Nm (1.8 m·kgf, 13 ft·lb)
6. Add the specified amount of the
recommended final transmission
oil, and then install and tighten
the oil filler cap.
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.11 L (0.1 Imp qt, 0.12 US qt)
w
8 Make sure that no foreign
8 Make sure that no oil gets on
7. Check the final transmission
6-7
material enters the final trans-
mission case.
the tire or wheel.
case for oil leakage. If oil is leak-
ing, check for the cause.
EWA00062
6