Yamaha VX150A Owner's Manual page 44

130 mm (5 in.)
104025*
w
Overpowering a boat may cause severe
instability. Do not install an outboard
motor with more horsepower than the
maximum rating on the capacity plate of
the boat. If the boat does not have a
capacity plate, consult the boat manufac-
turer.
EMU01302
Mounting Height
To run your boat at optimum efficiency,
the water-resistance (drag) of the boat
and outboard motor must be made as lit-
tle as possible. The mounting height of
the outboard motor greatly affects the
water-resistance. If the mounting-height
is too high, cavitation tends to occur, thus
reducing the propulsion and causing the
engine to overheat. If the mounting-
height is too low, the water-resistance will
increase and thereby reduce engine effi-
ciency. Mount the engine so the anti-cavi-
tation plate is about 130 mm (5 in.) above
the bottom of the boat.
NOTE:
8 The optimum mounting height of the
outboard motor is affected by the
boat/motor combination. Test runs at
different heights can help determine the
optimum mounting height.
For further details, consult your
Yamaha dealer or boat manufacture to
determine the proper mounting height.
8 Refer to the section "TRIMMING OUT-
BOARD MOTOR" for instructions on
setting the trim angle of the outboard.
3-3
E