Sidestand - Yamaha FZ6 Owner's Manual

1. Spring preload adjusting ring
2. Special wrench
3. Position indicator
NOTE:
G
Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.
G Use the special wrench included in
the owner's tool kit to make the ad-
justment.
Spring preload setting:
Minimum (soft):
1
Standard:
3
Maximum (hard):
7
INSTRUMENT AND CONTROL FUNCTIONS
3. Install the seat.
WARNING
This shock absorber contains highly
pressurized nitrogen gas. For prop-
er handling, read and understand
the following information before
handling the shock absorber. The
manufacturer cannot be held re-
sponsible for property damage or
personal injury that may result from
improper handling.
G
Do not tamper with or attempt to
open the gas cylinder.
G Do not subject the shock ab-
sorber to an open flame or other
high heat sources, otherwise it
may explode due to excessive
gas pressure.
G Do not deform or damage the
gas cylinder in any way, as this
will result in poor damping per-
formance.
G
Always have a Yamaha dealer
service the shock absorber.
3-15

Sidestand

EWA10220
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See further down for an explanation of
the ignition circuit cut-off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly as described
EAU15301
3
EWA10240