VIETA VNT7800BT Owner's Manual page 8

INSTALLATION
5. Mount the sleeve by inserting the
sleeve into the opening of the
dashboard and bend open the tabs
located around the sleeve with a
screwdriver. Not all tabs will be able
to make contact, so examine which
ones will be most effective. Bending
open the appropriate tabs behind the
dashboard to secure the sleeve in
place.
(1) Dashboard (2) Taps
6. Reconnect the wire harness and the
antenna and be careful not to pinch
any wires or cables.
7. Slide the unit into the sleeve until it
locks into place.
8. To further secure the unit, use the
supplied metal strap to secure the
back of the unit in place. Use the
supplied hardware (Hex Nut (M5mm)
and Spring Washer) to attach one
end of the strap to the mounting bolt
on the back of the unit. If necessary,
bend the metal strap to fit your
vehicle's mounting area. Then use
the supplied hardware (Tapping
Screw and Plain Washer) to attach
the other end of metal strap to a solid
metal part of the vehicle under the
dashboard. This strap also helps
ensure proper electrical grounding of
the unit.
Note to install the short threading
terminal of the mounting bolt to the
back of the unit and the other long
threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt; (3)
Hex Nut; (4) Spring Washer; (5)
Tapping Screw; (6) Plain Washer
9. Reconnect the cable to the vehicle
battery's negative (-) terminal. Then
replace the out trim ring.
Removing the unit
1. Make sure the ignition is turned off,
then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Remove the metal strap attached the
back of the unit (if attached).
3. Lift the top of the outer trim ring then
pull it out to remove it.
4. Remove the four screws on the left
and the right side of the unit then pull
the unit out of the dashboard.
8