Basic Operation - VIETA VNT7800BT Owner's Manual

BASIC OPERATION

TURNING ON/OFF THE UNIT
Press button on the front panel or
When the unit is on, press
press on the remote control will turn the unit off.
MONITOR PANEL ANGLE ADJUST
Press OPEN button on the front panel to draw out the monitor then press OPEN
again to draw in the monitor to normal position.
When the monitor drawing out, the front monitor can be turn down or turn up to some
degree by using
NOTE: The monitor is operated automatically. Do not draw the monitor out or turn it
upward or downward manually. Otherwise, the mechanism construction may be
harmed to some degree.
SOUND ADJUSTMENT
Repeatedly press the volume button on the front panel of the unit or SEL on the
remote control to select the desired adjustment mode. The adjustment mode will
change in the following order:
VOL BAS
(volume
After selecting your desired mode, you can adjust the current mode being displayed
by using the volume knob on the front panel or VOL+/VOL- buttons on the remote
control. Note: When P-EQ mode is activated (not in EQ OFF mode), press the
volume knob on the unit or SEL button on the remote control to select the modes.
And Bass /Treble modes are invalid. (Shown as below)
VOL
Note when the monitor is drawing in, press SEL button, the BRI, CON, and COL
three items can't be selected and adjusted.
REMOTE SENSOR
There is a remote sensor on the front panel. You can point the remote control to the
remote sensor and press functions keys on the remote control to control the unit.
Note to operate it within the certain operation angle.
button on the front panel for several seconds or
/ buttons (TILT up/down buttons) on the front panel.
TRE BAL
bass treble balance
BAL FAD
on the remote control to turn the unit on.
FAD BRI
fade brightness contrast color)
BRI CON
16
CON COL
COL