Table of Contents
Advertisement
holes that are not used must be masked.
4. Disassemble the bottom grille.
5. Unscrew the side hole plug and refit it on the
other side.
6. Disassemble the bottom hinge.
7. Remove the two doors.
8. Disassemble the middle hinge.
9. Remove the hole plugs and refit them on the
other side.
10.Turn the middle hinge through 180° and refit it on
the other side.
11. Reassemble the two doors and fix them with the
corresponding hinges.
12.Refit the bottom grille.
Important
For the alignement of the doors, adjust the middle
hinge horizontally, after having loosened the two
screws.
Attention
After completion of the door reversibility
operation, verify that the door gasket is adherent
to the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Building-in instructions
Dimensions of housing
Height 1446 mm
Depth
550 mm
Width
560 mm
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth
50 mm
Width
540 mm
18
D745
D119
D053
50 mm
D567
B
T H
PR01
A
min.
2
cm
200
Advertisement
Table of Contents
