Installation; Positioning; Electrical Connection; Cleaning The Interior - Zanussi ZR 220 TF Instruction Booklet

INSTALLATION

If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance.
This will prevent it from becoming a death-trap for a child.

Positioning

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +16 C and +32 C (class N) or
between +10 C and +32 C (class SN).
The class of your appliance is shown on its rating
plate.
For building into kitchen units follow the special
"Building-in" instructions given.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
P
P1
D114
Fig. 1

Door reversibility

Right opening
Remove pins (P) and (P1).
12
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive number 87/308
of 2/6/87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.

Building-in instructions

A
Left opening
Remove (P) from both sides and also remove the
door. Remove centre hinge (A) and refit it on the
opposite side. Refit the door and (P) on the left-hand
side and remove (P1) from the right-hand side.
P
P1