Preparation Of The Remote Control - Toshiba RD-XS24SB Owner's Manual

Introduction

Preparation of the remote control

1
Open the cover.
2
Insert batteries (R03 type).
Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
12
2
1
Notes on batteries
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly, follow the
instructions below.
• Do not insert batteries into the remote control in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries. Do
not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote
control.
• Do not use different types of batteries together, or mix old
and new batteries.
• If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage from
battery corrosion.
• If the remote control does not function correctly or if the
operating range is reduced, replace all batteries with new
ones.
• If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance : About 7 m from the front of the remote
sensor
Angle : About 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the recorder via the remote control.
Notes
• Direct the remote control at the remote sensor of the
recorder.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
30° 30°
Within about 7 m
TV DVD
INPUT SELECT OPEN/CLOSE
CHANNEL VOLUME INPUT SELECT CHANNEL
TOP MENU MENU
HDD DVD MENU TIMESLIP
MODE QUICK MENU
OPERATION
NUMBER
ENTER
RETURN EXIT