Operating Sequence -Autodrying - Zanussi ZWD 14581 W1 User Manual

6. At the end of the programme, the buzzer
sounds. Three flashing zeros «
appear on the display. At this point, begins
an «anti-crease phase», which lasts about
10 minutes. The door can be opened only
at the end of this phase.
Note!
If you wish to open the door before the anti-
crease phase or to interrupt it, press any
key or turn the programme selector dial to
Operating sequence - Autodrying
For NON-STOP programmes, the
recommended load size to wash and dry is 3,5
kg for cotton and 2 kg for synthetics.
Note!
Only with the timed drying, it is possible
also to dry up to 5 kg (see the drying time
table).
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the
selector dial to the selected wash
programme/fabric.
4. Select the dryness degree by pressing the
button or the drying duration by pressing
4
button (see the drying programmes).
5
5. Select the required options by pressing the
relevant buttons. If possible, do not select a
spin speed lower than that proposed by the
appliance to avoid a too long drying time so
saving energy.
In any case the reduction of the spin speed
is only possible after selecting drying.
22
any programme position (except «Off»), the
» will door can be immediately opened.
0.00
7. Turn the selector dial to the «Off» position
to switch the machine off. Remove the
laundry.
The lowest values you can select are the
following:
with timed drying - 900 r.p.m. for cottons and
700 r.p.m. for synthetics
with electronic drying - 900 r.p.m. for cottons
and synthetics
6. Start the programme by pressing the button
time remaining on the display is updated
every minute.
At the end of the programme the buzzer
sounds. Three flashing zeros «
appear on the display. At this point of the
programme, starts an anti-crease phase
which lasts about 10 minutes. During this
time the door is locked and the display
keeps showing the flashing zeros.
(If you wish to open the door before or during
the anti-crease phase, please follow the
instructions given in the previous chapter).
7. Turn the selector dial to the «Off» position to
switch the machine off.
8. Remove the laundry.
(NON-STOP programme)
. After the programme has started, the
8
»
0.00