Table of Contents
Advertisement
Options menu
Use this menu to adjust the global settings for the projector.
1.
Background Color: Allows you to choose the color of the background screen that will display
when there is no input signal detected.
2.
OSD Off (Secs): Sets the length of time the OSD will remain active after your last button press.
The range is from 5 to 60 seconds.
3.
Sleep Timer (Min): Sets the auto-shutdown timer. The timer can be set to a value between 10
minutes and 3 hours.
4.
OSD Position H: Adjusts the horizontal position of the OSD.
5.
OSD Position V: Adjusts the vertical position of the OSD.
6.
Reset Settings: Returns all settings to the factory preset values.
Setup menu
Use this menu to adjust basic image setup functions.
1.
Language: Sets the language for the OSD menus. There are seven languages available,
English, French, Spanish, German, Italian, Japanese, and Portuguese.
2.
Projection Mode: The projector can be installed on a ceiling or behind a screen, or with one or
more mirrors. You can choose from four settings. Contact your dealer for the ceiling mounting
bracket if you need to install the projector on a ceiling.
3.
Keystone: Corrects for trapezoidal distortion resulting from the angle of projection. It can provide
correction of up to ± 12 degrees.
4.
Altitude: Set the Altitude to High when you use the projector in an area higher than 3000 feet in
altitude or when the ambient temperature is higher than 40°C (100°F).
Note: Operating the projector in "High" mode may cause louder fan noise because of increased
fan speed necessary to improve overall cooling system and performance.
If the projector is used in any extreme environment (including those listed above), the projector
may begin auto shut-down to prevent overheating. If this happens, try setting the Altitude feature
to High. If this does not solve the problem, shut down the projector.
Note: This projector was not designed to operate in all harsh or extreme environments.
5.
Video Mode: When you set the Video Mode to Auto, the projector will automatically identify the
input signal type. If it fails, set the Video Mode to Manual and select a system from the list.
6.
NTSC Mode: If your residential area is using the NTSC system, set the your location as Japan or
US.
7.
Test Pattern: Use the Display menu Test Pattern feature when installing the projector without
an input signal, to help you adjust the image size and focus. The test pattern will display in the
aspect ratio setting of the Screen Size.
8.
Lamp
Lamp Power: Select High lamp power to project brighter images.
Using the High lamp power setting will decrease the life of the lamp faster than using the Standard
setting.
Lamp Time: Displays [Lamp Time] as a measure of when the lamp time should be replaced.
(Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches
2,000 hours, consult with a store about getting TLPLMT70 replacement lamp (sold separately)
prepared.
Reset Lamp Timer: Resets the lamp timer. This should only be done after the lamp has been
replaced.
28
Menus
p. 15
Advertisement
Table of Contents
