Table of Contents
Advertisement
Accessing the Inside of the SuperServer 5015B-MT
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SATA drives
and SATA backplane have been properly installed and all essential connections
have been made.
Checking the Drives
1.
All drives can be accessed from the front of the server. For servicing the
CD-ROM drive, you will need to remove the top chassis cover. The SATA
disk drives can be installed and removed from the front of the chassis without
removing the top chassis cover.
2.
Refer to Chapter 6 if you need to reinstall a CD-ROM drive to the system.
3.
Depending upon your system's confi guration, your system may have one or
more SATA drives already installed. If you need to install SATA drives, please
refer to the appropriate section in Chapter 6.
Checking the Airfl ow
1.
Airfl ow is provided by four high-performance 4-cm input fans. The system
component layout was carefully designed to promote suffi cient airfl ow through
the small 1U rackmount space.
Chapter 2: Server Installation
Figure 2-4.
2-9
Advertisement
Table of Contents
