connect equipment and receivers to different outlets; or consult the radio or television
manufacturer or an experienced radio/TV technician for help.
Look Out For Signs
There are some places where RF signals could constitute a hazard, such as health-care
facilities and construction sites. If you are not sure, look around for signs indicating that
two-way radios or mobile phones should be turned off.
In addition, turn off and do not charge your device if you are in any area with a potentially
explosive atmosphere, as sparks in such areas could cause an explosion or fire. Such
areas are usually, but not always, clearly identified, and include areas where you would
normally be advised to turn off your vehicle engine.
FCC Compliance Statement
This device and its related accessories such as the adaptor (the "Products") comply with
part 15 of the FCC Rules. Operation of each Product is subject to the following two
conditions: (1) each Product may not cause harmful interference, and (2) each Product
must accept any interference received, including interference that may cause undesired
operation.
Note: The Products have been tested and found to comply with the limits for a Class B
digital device or external switching power supply, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. The Products generate, use and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If a Product does cause harmful
interference to radio or television reception, which can be determined by turning the
Product off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to a Product by the user that are not expressly approved by the
party responsible for compliance could cause the Product to no longer comply with the
FCC Rules.
Information Regarding Exposure to Radio Frequency Energy
Your Device is designed and manufactured not to exceed the emission limits for exposure
to RF energy set by the Federal Communications Commission of the United States (FCC).
Information on your Device is on file with the FCC and can be found under the Display
Kindle User's Guide
35
Appendix A
Product Information