Watch For Signs; Fcc Compliance Statement; Information Regarding Exposure To Radio Frequency Energy; Canadian Compliance Statement - Amazon Tablet PC User Manual

2nd edition
Hide thumbs Also See for Tablet PC:
Table of Contents

Advertisement

Watch for Signs

There are some places where RF signals could constitute a hazard, such as health care
facilities, and construction sites. If you are not sure, look around for signs indicating that two-
way radios or cell phones should be turned off.
In addition, turn off and do not charge your device if you are in any area with a potentially
explosive atmosphere, as sparks in such areas could cause an explosion or fire. Such areas
are usually, but not always, clearly identified, and include areas where you would normally be
advised to turn off your vehicle engine.

FCC Compliance Statement

This device and its related accessories like the adaptor (the "Products") comply with part
15 of the FCC Rules. Operation of each Product is subject to the following two conditions:
(1) each Product may not cause harmful interference, and (2) each Product must accept any
interference received, including interference that may cause undesired operation.
Note: The Products have been tested and found to comply with the limits for a Class B
digital device or external switching power supply, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. The Products generate, use and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If a Product does cause harmful interference to radio or
television reception, which can be determined by turning the Product off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to a Product by the user that are not expressly approved by the
party responsible for compliance could make the Product no longer comply with the FCC
Rules.

Information Regarding Exposure to Radio Frequency Energy

Your Device is designed and manufactured not to exceed the emission limits for exposure
to RF energy set by the Federal Communications Commission of the United States (FCC).
Information on your Device is on file with the FCC and can be found under the Display Grant
section of
http://transition.fcc.gov/oet/ea/
which can be found on the back of the Device.

Canadian Compliance Statement

This device complies with the Canadian ICES-003 Class B specifications.
This device complies with RSS 210 of Industry Canada. This Class B device meets all the
requirements of the Canadian interference-causing equipment regulations.
Kindle Paperwhite User's Guide, 2nd Edition
Appendix A Product Information
after searching on the FCC ID for your Device,
32

Advertisement

Table of Contents
loading

This manual is also suitable for:

Paperwhite

Table of Contents