Electrical Connection; Building-In - Zanussi ZI 1603 Instruction Booklet

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Important
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.
The Manufacturer
responsibility
precautions are not observed.

Building-in

Dimensions of the recess
ZI 1603
Height of housing (1) 880
Depth of housing (2)
Width of housing (3)
PR0
It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth 50 mm
Width 540 mm
40
declines
if the above
ZI 2403
1225
550 550
560 560
3
1
2
This appliance complies with the following E.E.C.
Directives:
- 87/308 EEC of 2/6/87 relative to radio
interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage
Directive)
and subsequent modifications.
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Attention!
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
all
safety
mm
mm
mm
1. Slide the appliance into the recess, pushing it
against the wall on the handle side.
2. Apply joint the sealing strip as shown in figure.
D022
D132
1
2