Zanussi ZI 1603 Instruction Booklet page 9

3. Open the door and push the appliance against the
side of the kitchen unit opposite to that of ap-
pliance hinges. Fasten the appliance with 4
screws (I) provided in the kit included with the
appliance.
C
D
E
4. Snap vent grille (B) and hinge cover (E) into
position.
Apply covers (C-D) on joint cover lugs and into
hinge holes.
A
C
PR266
5. Separate parts A, B, C, D as shown in the figure.
I
B
B
D
PR166
6. Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws
supplied.
C
P R 33 /2
7. Fix cover (C) on guide (A) until it clips into place.
PR167
8. Open the appliance door and the furniture door at
90¡. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with ¯ 2 mm
at 8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
A
A
8mm
A
B
41