Continuous Scan Settings; Continuous Scan - Sleep Time Out; Continuous Scan - Trigger Delays; Continuous Scan - Duplicate Scan Delay - Code Reader 2.0 User Manaul

2.11 - Continuous Scan Settings

2.11.1 - Continuous Scan - Sleep Time Out

Scan one of the codes below to set the amount of time a cabled CR2 will operate in continuous scan mode before entering
sleep mode:
Cabled - 2 hours
Scan one of the codes below to set the amount of time an uncabled CR2 will operate in continuous scan mode before
entering sleep mode:
Uncabled - 5 minutes (Default)
Note: This function is only recommended for short term use because of battery consumption.

2.11.2 - Continuous Scan - Trigger Delays

Scan the following codes to set delay time between scans:
0 Seconds (Default)

2.11.3 - Continuous Scan - Duplicate Scan Delay

Scan the following codes to set the delay time for reading duplicate codes:
0 Seconds (Default)

2.12 - Motion Detection Scan Settings

Scan the following codes to set the reader to read when it detects motion in its scanning zone.
On
Save Settings
Cabled - Always (Default)
Uncabled - 15 Minutes
1 Second
1 Second
Off (Default)
Uncabled - 30 Minutes
3 Seconds
3 Seconds
C001537_15_CR2_User_Manual 36