Connecting With A Computer (Analog Connection) - Mitsubishi Electric MDT5525 User Manual

P-4 Connection procedure (continued)

Connecting with a computer (analog connection)

Analog connection:
(1) Connect a signal cable (mini D-SUB 15-pin – mini D-SUB 15-pin) (accessory) to the D-SUB/YPbPr IN connector.
(2) Select [D-SUB] using the INPUT button on the monitor or the D-SUB button on the wireless remote control. At the moment of
the selection, the audio is automatically switched to [ANALOG].
Audio connection:
• Connect an audio cable (ø3.5-mm stereo mini) (commercially available) to the AUDIO ANALOG IN connector.
Because the audio is automatically switched to [ANALOG] when [D-SUB] is selected, the audio is output just by connecting the
cable.
LCD monitor
(side)
LCD monitor (rear)
AUDIO
ANALOG IN
The monitor automatically distinguishes the timings shown in the table below and sets the screen information. When a PC or other
device is connected, it automatically displays images properly. See the page describing AUTO SETUP/AUTO ADJUST.
<Factory preset timing>
Frequency
Resolution
Horizontal
1 640 x 480 31.5 kHz
2 800 x 600 37.9 kHz
3 1024 x 768 48.4 kHz
4 1280 x 720 45.0 kHz
5 1280 x 768 47.8 kHz
6 1280 x 800 49.7 kHz
7 1360 x 768 47.7 kHz
8 1440 x 900 55.9 kHz
NOTE:
When a signal other than 1920 x 1080 is input, characters may be blurred and fi gures and objects may be distorted.
Images may not be displayed correctly depending on the video card or driver being used.
Audio cable
(ø3.5-mm stereo mini)
Remarks
Vertical
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
English-21
Signal cable
(mini D-SUB 15-pin – mini D-SUB 15-pin)
D-SUB/YPbPr IN
Frequency
Resolution
Horizontal
9 1280 x 1024 64.0 kHz
10 1400 x 1050 65.3 kHz
11 1680 x 1050 64.7 kHz
12 1600 x 1200 75.0 kHz
13 1920 x 1080 56.2 kHz
14 1920 x 1080 67.5 kHz
15 1920 x 1200 74.0 kHz
Personal computer
(Analog RGB)
To D-SUB output
To audio output
Remarks
Vertical
60 Hz
60 Hz
60 Hz
60 Hz
50 Hz
60 Hz Recommend timing
60 Hz CVT Reduced Blanking