Table of Contents
Advertisement
of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
To remove or reinstall the wall mount, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 73.
4. Remove the hard disk drive. See "Replacing the hard disk drive" on page 74.
5. Remove the three screws (
Figure 16. Removing the computer wall mount
6. Note the routing of the thermal sensor cable. Then disconnect the thermal sensor cable
system board. See "System board parts and connectors" on page 71. Then lift the wall mount off
the computer main bracket
7. To reinstall the computer wall mount, position the wall mount on the computer main bracket and align
the screw holes in the wall mount with those in the computer main bracket.
8. Reinstall the three screws to secure the wall mount to the computer main bracket.
1
and
3
) that secure the wall mount to the computer main bracket.
2
from the
.
Chapter 8
Replacing FRUs
83
Advertisement
Table of Contents
