Table of Contents
Advertisement
27. Reinstall the wall mount. See "Removing or reinstalling the wall mount" on page 82.
28. Reinstall the hard disk drive. See "Replacing the hard disk drive" on page 74.
29. Connect all cables that were disconnected from the system board. See "System board parts and
connectors" on page 71.
30. Go to "Completing the parts replacement" on page 113.
The failing system board must be returned with a microprocessor socket cover to protect the pins during
shipping and handling.
To install the microprocessor socket cover, do the following:
1. Release the lever securing the microprocessor retainer and open the retainer to access the
microprocessor.
2. Grasp the microprocessor on the sides and lift it straight up and out of the socket. Do not touch the
contacts on the microprocessor socket.
3. Note the orientation of the socket cover. Align the notches
the alignment keys
4. Install one side of the socket cover into the microprocessor socket as shown.
Figure 38. Installing the socket cover
Note: Your microprocessor socket and cover might look slightly different from the illustration.
5. Carefully press the other side of the socket cover downwards until the socket cover snaps into place.
110
ThinkCentre Hardware Maintenance Manual
2
of the microprocessor socket.
1
of the microprocessor socket cover with
Advertisement
Table of Contents
