Lenovo ThinkCentre 7570 Hardware Maintenance Manual page 60

Diagnostic Error Code
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
025-195-XXX IDE interface Test aborted by user
025-196-XXX IDE interface test halt, error threshold
exceeded
025-197-XXX IDE interface test warning
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface failure
030-027-XXX SCSI interface Configuration/Setup error
030-03X-XXX 030-04X-XXX SCSI interface error
030-195-XXX SCSI interface Test aborted by user
54
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. IDE signal cable
2. Check power supply.
3. Reseat IDE signal cable.
4. IDE device
5. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 39.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 39.
2. Flash the system and re-test. See "Flash update
procedures" on page 193.
3. Go to "Undetermined problems" on page 64.
1. Go to "Undetermined problems" on page 64.
2. Flash the system and re-test. See "Flash update
procedures" on page 193.
3. Replace component under function test.
No action
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
1. SCSI signal cable
2. Flash the system. See "Flash update procedures"
on page 193.
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed.
5. System board
Information only Restart the test, if necessary.