Rear-Panel Connections (Amplifier) - Harman Kardon MAS 101 Owner's Manual

MAS SYSTEM
Right and Left Speaker Output Terminals: Use two-conductor speaker wire to
connect each set of terminals to the correct speaker. Remember to observe the
correct polarity (positive and negative connections).
Input From Controller: Connect the included ribbon cable to this connector and to
the corresponding connector on the MAS controller. This cable passes audio signals
from the controller to the amplifier, and it transfers DC power from the amplifier to
the controller. If this cable is ever damaged, do not use it, and contact Harman Kardon
for a replacement.
AC Power Input: After you have made all other connections, plug the AC power cord
into this receptacle and into an unswitched wall outlet.
NOTE:
MAS 101/111 systems require 23OV, 50/60Hz AC current. MAS 102 systems
require 120V, 60HZ AC current
Rear-Panel Connections
Amplifier
7