Rear Panel Connections - Harman Kardon MAS 100 Service Manual

REAR-PANEL CONNECTIONS
CONTROLLER
FM Antenna
Terminal
Update Switch
FM Antenna Terminal:
here.
DAB Antenna Terminal (MAS 110 Only):
included DAB antenna wire lead here to enjoy programming from digital
DAB, DAB+ or T-DMB-Audio radio stations available in your area.
USB Port B:
Connect a compatible USB device here to enjoy play-
back of audio MP3 or WMA files. Although most USB flash and hard-disk
drives in the FAT32 file format, as well as many MP3 players, are com-
patible with the MAS 100 and MAS 110 systems, due to the wide variety
of manufacturers, playback cannot be guaranteed. Do not connect an
iPod or iPhone to this port. Do not connect a personal computer or any
peripherals to this port.
Optical 1/2 and Coaxial 1/2 Digital Audio Inputs:
Connect a source device's optical or coaxial digital audio output to the
corresponding input. Only the PCM uncompressed format is supported.
TV and AUX Analog Audio Inputs:
analog audio outputs of a television or any source device to enjoy play-
back through the high-performance MAS system.
Phono Input:
Connect the outputs of a moving magnet
(MM) type turntable to this input. Do not connect any other type of turn-
table to this input, and do not connect the outputs of
an MM-type turntable to any other analog audio inputs on the MAS 100
or MAS 110 without using a phono preamp, available separately from
many electronics stores.
Input:
To enjoy playback of audio materials stored on a
compatible iPod (see page 4), connect The Bridge II dock (included with
the MAS 110/240 system; available separately for the MAS 100 and MAS
110/230 systems). Make sure the insert for The Bridge II is installed,
and install the appropriate dock adapter for your iPod within the insert, as
shown in Figure 1 on page 10.
harman/kardon
USB Port
Optical 1/2 Digital
Audio Inputs
DAB Antenna
Terminal
(MAS 110 only)
RS-232
Serial Port
Connect the included FM antenna wire
Connect the
Connect the
TV and AUX
Coaxial 1/2 Digital
Analog Audio
Audio Inputs
Inputs
Analog Audio
Outputs
Coaxial Digital
Audio Output
Output to
Amplifier
Analog Audio Outputs:
audio inputs of an audio recorder. When a source
connected to the MAS system is playing, the signal will be
available at these outputs for recording.
Coaxial Digital Audio Output:
to the coaxial digital audio input of a digital audio recorder. When a
source connected to the MAS system is playing, the signal will be avail-
able at this output for recording.
NOTES:
The MAS system does not
digital domain, or digital sources to the analog domain
for recording.
It is the user's responsibility to comply with all laws
pertaining to the copying of audio materials.
Output to Amplifier:
connector and to the corresponding connector on the MAS amplifier.
This cable passes audio signals from the controller to the amplifier, and
it transfers DC power from the amplifier to the controller. If this cable
is ever damaged, do not use it, and contact Harman Kardon, Inc., for a
replacement.
RS-232 Serial Port:
Do not connect it to any devices unless instructed to do so at the time a
system upgrade is released.
Update Switch:
This switch is used only for system upgrades.
Leave it in the "N" position for normal operation unless instructed to
switch it to the "U" position to install a system update.
MAS 100 / MAS 110 / MAS 1 Service Manual
Phono Input
The Bridge II
Input
Connect these outputs to the analog
Connect this output
convert analog sources to the
Connect the included ribbon cable to this
This port is used only for system upgrades.
Page 4 of 36