Use; The Control Panel - Zanussi ZTB 200 Instruction Booklet

125980991 -gb.qxp 2005-03-15

Use

The control panel

1 Programme chart
This will help you to select the correct programme for
drying.
2 Mains-ON light
Comes on when the appliance is switched on
(ON/OFF button - "AAN/UIT" pressed down) and
goes out when this button is released.
3 ON/OFF button - "AAN/UIT"
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low temperature button - "LAGE
TEMP."
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
5 Buzzer OFF button - "ZOEMER UIT"
A buzzer sounds during the anti-creasing phase.
Press this button when selecting the programme if
you wish to switch the buzzer off. The corresponding
light illuminates.
13:50 Page 9
6 Start button - "START"
Press this button for about 2 seconds to start the
dryer after having selected the programme.
If the door is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the programme
from the point at which it was interrupted.
This button must also be pressed after a power cut.
In both cases light or
phase in progress) flashes to remind you that the
start button needs to be pressed again.
7 Programme phase indicator lights
These lights indicate the various phases of the
programme as they are being performed.
"Drying" light
This light indicates that the appliance is in the drying
phase.
"Cooling" light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light or is flashing, this means that the Start
button needs to be pressed again for the programme
to resume.
"End of programme" light
This light flashes at the end of the cooling phase and
during the anti-creasing phase.
9
(depending on the