Zanussi ZHC 9454X User Manual page 18

Make sure that the cooker hood is disconnected from the power supply before carrying out
the installation.
Remove the anti-fat filter and the carbon filter support frame.
• Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that
the mid line printed on the template matches with the centre line previously drawn, the lower side
of the template corresponds to the lower side of the hood once mounted (2).
• Make 4 holes; 2 above to fix the support bracket of the hood and 2 below for definitely fixing the
hood. Insert 4 dowels in the wall.
Fix the support bracket of the hood with 2 screws (3).
• Drill two holes Ø 8mm on the upper side close to the ceilling, fit two wall plugs (4) (In case the
hood is to be used in filter version, mount the deflector F on the chimney support with 4 screws)
and fix the chimney support G with two screws (5).
• Hook the hood on (6).
• Adjust the position of the hood (7-8)
• Fix the hood definitively with 2 screws and washers (9).
• Fit an exhausting pipe (10) to connect the outlet hole B of the hood to the outside (Extractor
hood) or to the deflector F (Filter version).
• Make electrical connection (11).
18