If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Department, at the address below or visit our website at www.zanussi.co.uk...
• Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Zanussi Service Force Centre. Always insist on genuine spare parts.
Page 5
To Operate Select the required fan speed and light if required. The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation The cooker hood is supplied specified for use in the recirculation mode with the charcoal filter fitted.
Page 7
Position the new charcoal filter in the position marked and while holding the filter replace the fixing hooks as illustrated. This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended.
SERVICE AND SPARE PARTS For general assistance with your appliance or for further information on Zanussi products please contact our Customer Care Department at the address below or visit our website at: www.zanussi.co.uk...
Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood.
Drilling the Ceiling/Support Shelf Using a plumb line mark the centre point of the hob on the ceiling or support shelf. Position the drilling template item 21 on the ceiling or support shelf ensuring the template is aligned correctly with the angles of the hob.
On completion check that the base is stable even if the frame is subject to movement. The installer must provide ample support where the ceiling or support shelf is not strong enough by installing cross beams over the joists or above the shelf to ensure the frame is quite rigid at its mounting point.
Recirculation The cooker hood is supplied specified for use in the recirculation mode, with the charcoal filter fitted. In the recirculation mode contaminated air is passed through the charcoal filter to be purified and recirculated into the kitchen through the grille outlets on either side of the chimney.
Electrical Connection Push fit the Cmd connecter on the cable from the motor housing to the one from the control box. Place the Cmd connector in the junction box 24 and clamp it together using two Ø2.9x6.5mm screws 12e. Fix the junction box 24 to the hood body 1 using the two Ø2.9x9.5mm screws 12c.
Need help?
Do you have a question about the ZHC 951 and is the answer not in the manual?
Questions and answers