Table of Contents
Advertisement
What to do if ...
Problem
The cooking zones are
not functioning.
The cooking zones
cannot be selected /
Appliance does not re-
act to the control panel
input
The residual heat indi-
cator is not displaying
anything
Er03
is displayed
Er21
is displayed
Er25
is displayed
(only for 10 seconds)
Possible cause
No cooking zone se-
lected
More than 10 seconds
has passed since the
appliance was
switched on
The child safety device
is activated
The sensor fields are
partly covered by a
damp cloth or with liq-
uid
Safety cut-out has
been triggered
The cooking zone was
only on for a short time
and is therefore not hot
Several sensor fields
were touched at the
same time
Safety cut-out due to
overheating.
Appliance is incorrectly
connected
Remedy
Select cooking zone
within 10 seconds of
switching on (Decimal
point lights up)
Switch on the appli-
ance again.
Select cooking zone
within 10 seconds of
switching on
Deactivate the child
safety device (See sec-
tion "Child safety de-
vice")
Remove the cloth or the
liquid
Switch on the appli-
ance again
If the cooking zone is
supposed to be hot,
call your local Service
Force Centre.
Only touch one sensor
field
Let the appliance cool
down.
Remove cookware.
Disconnect the appli-
ance from the electrical
supply and have it con-
nected properly
15
Advertisement
Table of Contents
