Table of Contents
Advertisement
Levelling
The appliance must be level. Level the appliance by
adjusting the two adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be removed.
Door Reversal
If required the opening direction of the door can be
changed as follows:
To reverse the bottom hinge assembly proceed as fol-
lows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of
the appliance on a stool or something similar.
Unscrew the adjustable feet situated on both sides (2
pieces), in addition the screws fixing the lower door
holders (2 pieces) respectively screw on the other
side.
Take off the freezer door by pulling it slightly down-
wards.
Unscrew the top door hinge pin of the refrigerator
then screw it back on the other side.
Fit the freezer door on the upper door hinge pin.
12
Put over the pin in the lower door holding plate in the
direction of the arrow.
Fix the plate on the other side leaving the position of
the door unchanged.
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
Put the handles on the other side and put the plastic
covering nails supplied in the plastic bag of this
instruction book into the holes set free.
Put the appliance into it's place, set it level and plug it
into the mains socket.
Advertisement
Table of Contents
