or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug.
Operation Switching on Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Temperature regulation The temperature is automatically regulated. To operate the appliance, proceed as follows: •...
Helpful hints and tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor.
Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor com- pressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
Problem Water flows on the rear plate of the refrigerator. Water flows into the refrigerator. The water outlet is clogged. Water flows on the ground. The temperature in the appliance is too low. The temperature in the appliance is too high. The temperature in the refrigera- tor is too high.
Technical data Dimension The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. En- sure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm .
In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force. The After Sales Service specialist will carry out the rever- sibility of the doors at your cost. Electrical Connection Caution! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Page 12
To buy accessories, consumables and spare parts at our online shop please visit: www.zanussi.co.uk www.zanussi.com...
Need help?
Do you have a question about the ZRG717CW and is the answer not in the manual?
Questions and answers