SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •...
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •...
• room temperature If the ambient temperature is high or • how often the door is opened the appliance is fully loaded, and the • the quantity of food stored appliance is set to the lowest • the location of the appliance. temperature, it may run continuously causing frost to form on the rear wall.
HINTS AND TIPS NORMAL OPERATING SOUNDS • do cover or wrap the food, particularly if it has a strong flavour The following sounds are normal during operation: • position food so that air can circulate freely • A faint gurgling and bubbling sound from coils around it sound when refrigerant is pumped.
• the freezing process takes 24 hours no further HINTS FOR STORAGE OF FROZEN FOOD food to be frozen should be added during this To obtain the best performance from this appliance, period; you should: • freeze only top quality, fresh and thoroughly •...
appliance, over the motor compressor, where it Defrost the freezer when the frost layer reaches a evaporates. thickness of about 3-5 mm. It is important to periodically clean the defrost water 1. Switch off the appliance, or pull out electrical drain hole in the middle of the refrigerator plug from the wall socket.
Page 9
Problem Possible cause Solution The mains plug is not connec- Connect the mains plug to the ted to the mains socket cor- mains socket correctly. rectly. There is no voltage in the Connect a different electrical mains socket. appliance to the mains socket. Contact a qualified electrician.
Page 10
Problem Possible cause Solution The temperature in the appli- The temperature regulator is Set a higher/lower tempera- ance is too low/too high. not set correctly. ture. The door is not closed correct- Refer to "Closing the door". The food products' tempera- Let the food products temper- ture is too high.
Make sure that the light switches on. 3. If necessary, replace the defective door gaskets. Contact the Authorised Service CLOSING THE DOOR Centre. 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". INSTALLATION WARNING! Refer to Safety chapters. POSITIONING Install the appliance in a dry, well ventilated indoors where the ambient temperature corresponds to the...
100 mm 15 mm 15 mm 6. Fit the appliance door on the upper door hinge DOOR REVERSIBILITY pin. 7. Remove the lower hinge. Put over the pin in the WARNING! Before carrying out any direction of the arrow. operations, remove the plug from the 8.
Page 13
Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red.
Need help?
Do you have a question about the ZRG14800WV and is the answer not in the manual?
Questions and answers