Existing Windows Xp Installation - Maxtor SATA/150 Installation Manual

6. Choose Win 2000 Maxtor SATA/150 PCI Card from the list that appears on screen, and then press Enter.
7. Press S to use the driver on the floppy disk and then press Enter to continue with installation.
8. The Windows 2000 Setup screen will appear again saying "Setup will load support for the following mass
storage devices:" The list will include Win 2000 Maxtor SATA/150 PCI Card. If there are any additional
devices to be installed, specify them now then continue to the next step.
From the Windows 2000 Setup screen, press Enter. Setup will now load all device files and complete the
Windows 2000 installation.

Existing Windows XP Installation

If you have an existing installation of Windows 2000 or XP on a SATA or Ultra ATA drive that you wish to connect to the SATA/
150 PCI card, DO NOT connect the drive to the card yet. Leave the drive attached to its current controller. You must install the
Windows driver for the SATA/150 PCI Card before connecting your hard drive to the card.
The following section details the installation of SATA/150 PCI Card drivers on a system that has Windows XP
already installed and running.
1. After installing the SATA/150 PCI Card and rebooting your system, Windows XP will detect a Mass Storage
Controller and display the Found New Hardware Wizard. Insert the driver diskette or CD. (If you inserted a
CD, close the language chooser that appears.)
2. In the Found New Hardware Wizard window, select "Install from a list or specific location (Advanced)" and
click Next.
Select "Search for the best driver in these locations," then select the "Include this location in the search"
checkbox and click the Browse button.
Install Windows Driver 19