Initial Setting The Area Code; Adjust The Settings - LG DKS-8500Q Manual

KD300_KD350_ENG_53119802 7/1/08

Initial Setting the Area Code

After factory setting, to set the Area code you have to as below.
1 Display setup menu:
2 Select LOCK menu on the first level:
3 Move to second level:
Appears the activated Area code on the
third level.:
4 Move to third level:
5 Enter the new password:
6 Recheck entered new password:
7 Select a code for a geographic area:
After select,Rating and Password will be
activated.(page 17)
8 To confirm, press:
Make sure to finish setting the Area Code
before leaving the setup menu If you cannot
set the Rating and password.

Adjust the settings

1 Display setup menu :
2 Select a desired option on the first level:
3 Move to second level:
4 Select a desired option on the second level:
5 Move to third level:
6 Change the setting:
9:33 AM Page 7
ON REMOTE
SETUP
v V
B
B
numerical buttons
(0-9) and ENTER
numerical buttons
(0-9) and ENTER
vV b B
ENTER
ON REMOTE
SETUP
v v V V
B B
v v V V
B B
, ENTER
v v V V
Adjust the settings - more you can do
Adjust the language settings
OSD – Select a language for the Setup menu and on-screen display.
In case there is displayed as "-" or other error mark on display when you
change OSD, do as follows;
- Restart the unit
- Change function
- Disconnect and connect USB device.
Disc Menu/Audio/Subtitle – Select a language for the Menu/Audio/Subtitle.
[Original]: Refers to the original language in which the disc was recorded.
[Others]: To select another language, press number buttons then ENTER to enter
the corresponding 4-digit number according to the language code list in the refer-
ence chapter (see page 17). If you make a mistake before pressing ENTER,
press CLEAR.
[OFF] (for Disc Subtitle): Turn off Subtitle.
Adjust the display settings
TV Aspect – Select which screen aspect to use based on the shape of your TV
screen.
[4:3]: Select when a standard 4:3 TV is connected.
[16:9]: Select when a 16:9 wide TV is connected.
Display Mode – If you selected 4:3, you'll need to define how you would like
widescreen programs and films to be displayed on your TV screen.
[Letterbox]: This displays a widescreen picture with black bands at the top and
bottom of the screen.
[Panscan]: This fills the entire 4:3 screen, cropping the picture as necessary.
TV Output Select – Select an option according to the TV connection type.
[YPbPr]: When your TV is connected with the COMPONENT/PROGRESSIVE
SCAN jacks on the unit.
[RGB]: When your TV is connected with the SCART jack.
If you change TV Output Select to RGB from YPbPr on the setup menu
especially when connecting the unit in the way of component video connection, the
screen turns black. In that case, connect the video cable to MONITOR jack and
select YPbPr on the setup menu again.
Progressive Scan (For Component Video connections) – Selects whether
the COMPONENT/PROGRESSIVE SCAN OUTPUT jacks output progressive
signal. If your TV accepts progressive format signals, you will enjoy accurate
color reproduction and high quality image by selecting [ON]. If your TV does not
accept progressive format signals, select [OFF].
If you set Progressive Scan to [On] in error, you must reset the unit. First,
remove the disc in the unit. Next, press and hold STOP on the remote control for
five seconds. The video output will be restored to the standard setting, and a pic-
ture will be visible on your TV.
7
DVD Karaoke System