Table of Contents
Advertisement
KD450 WRUSLL ENG-8639
Initial Setting the Area Code
When you use this unit for the first time, you have to set the Area
Code as shown below.
1 Display setup menu :
2 Select LOCK menu on the first level:
3 Move to second level :
The activated Area Code appears on the
second level. :
4 Move to the third level
5 Enter a new password
6 Recheck the entered new password
7 Select a code for a geographic area :
After select, Rating and Password will be
activated.
8 To confirm what you press :
Make sure to finish setting the Area Code
before leaving the setup menu if you cannot
set the rating and Password
Adjusting the general settings
1 Display setup menu
2 Select a desired option on the first level
3 Move to the second level
4 Select a desired option on the second level
5 Move to the third level
6 Change the setting
Downloaded From DvDPlayer-Manual.com LG Manuals
1/24/11
7:08 PM
Page 7
ON REMOTE
SETUP
U U u u
i i
i i
numerical buttons
(0-9) and ENTER
numerical buttons
(0-9) and ENTER
U U u u I I i i and
ENTER
ENTER
ON REMOTE
SETUP
U U u u
i i
U U u u
i i
U U u u , ENTER
Adjusting the general settings - more you can do
Adjusting the language settings
OSD – Selects a language for the Setup menu and on-screen display.
Disc Audio/ Disc Subtitle/ Disc Menu – Selects a language for the Audio/
[Original]: Refers to the original language in which the disc was recorded.
[Other]: To select another language, press number buttons then ENTER to
enter the corresponding 4-digit number according to the language
code list in the reference chapter.
[Off] (for Disc Subtitle): Turns off Subtitle.
Adjusting the display settings
TV Aspect – Select which screen aspect to use based on the shape of your TV screen.
[4:3]: Select when a standard 4:3 TV is connected.
[16:9]: Select when a 16:9 wide TV is connected.
Display Mode – If you selected 4:3, you'll need to define how you would like
widescreen programs and films to be displayed on your TV screen.
[Letterbox]: This displays a widescreen picture with black bands at the top
and bottom of the screen.
[Panscan]: This fills the entire 4:3 screen, cropping the picture as necessary.
TV Output Select – Select an option according to the TV connection type.
[YPbPr]: When your TV is connected with the COMPONENT VIDEO
OUT/PROGRESSIVE SCAN jacks on the unit.
[RGB]: When your TV is connected with the SCART jack.
- If you change TV Output Select to RGB from YPbPr on the setup menu
especially when connecting the unit in the way of component video connec-
tion, the screen turns black. In that case, connect the video cable to VIDEO
OUT jack and select YPbPr on the setup menu again.
Menu/ Subtitle.
7
Advertisement
Table of Contents
