Table of Contents
Advertisement
Setting the hob for the
new gas type
1. If necessary, activate the hob by
touching the main ON/OFF Control
for about 3 seconds.
2. Touch the Timer Control
to select the auxiliary burner (front left
burner) on the burner selection display .
3. Touch the Increasing Control
the finger on it until the value 99 appears
on the time display. Then, touch the
Decrasing Control
on it until the value 80 is displayed.
4. Then, touch the Increasing Control
until 83 is displayed. At this point, the
hob is set to the "Gas Change" mode
and the current gas setting appears on
the display:
n0
-
stands for gas G20 (20 mbar)
n1
-
for gas G30 (28-30/37 mbar).
IMPORTANT: setting
allow the hob to function.
repeatedly
and hold
and hold the finger
n2
does not
33
Advertisement
Table of Contents
