Installation Instructions - Sharp R-231F Operation Manual

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity, (do not remove the waveguide cover, item 10 on page
E-4), and the feature sticker from the outside of the door, if there is one. Check the unit for any damage, such
as a misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door.
If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable
3. Fit the roller stay and turntable referring to OVEN DIAGRAM on page E-4. Place the roller stay on the bottom
of oven and seat the turntable on the roller stay, while aligning well with the coupling in the centre. NEVER
use the oven without the turntable and roller stay.
4. The oven should not be installed in any area where heat and steam are generated, for example, next to a
conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow at least 15cm on top of the oven for free air space.
This oven is not designed to be built-in to a wall or cabinet.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage and frequency must correspond to the one indicated on the rating plate.
6. WARNING-THIS APPLIANCE MUST BE EARTHED.
If the socket outlet in your house is not compatible with the plug supplied, cut-off the mains plug and fit an
appropriate type, observing the wiring cord below.
If you are unsure how to do this get help from an electrician.
IMPORTANT - The wires in power supply cord are coloured in accordance with the following code:
As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured brown.
NOTE: Under no circumstances should the cut-off plug be inserted into a socket outlet as a serious electric
shock may occur.
2) Roller stay
Green-and-yellow
Blue
Brown
or coloured green or green-and-yellow.
3) Operation manual
: Earth
: Neutral
: Live
E-3