Yamaha GLADIATOR Ower's Manual page 76

'CO' EMISSION LEVEL MEASUREMENT
2. PROCEDURE FOR MEASUREMENT OF "CO" EMISSION LEVEL
2.1 IMPORTANT : "CO" Measurement Equipment must be duty calibrated.
2.2 Check for "NO LEAKAGE" from Exhaust System.
2.3 Starter Lever should be in OFF position.
2.4 All Electricals should be in OFF position.
2.5 Set the Idle speed of the Engine in warmed up condition of Motorcycle as specified.
MODEL
GLADIATOR
2.6 Insert the Sampling probe of the Exhaust Gas Analyser inside the Exhaust Muffler of the
Motorcycle.
2.7 • If the reading is within specified limits then it is acceptable.
• If the reading exceeds the norm of 3.5% (by volume) have it adjusted by YAMAHA
Authorised Dealer.
3. LIST OF COMPONENTS IMPACTING "EMISSION"
a. Air Filter
b. Carburetor
c. Cylinder
d. Piston Ring & Piston h. Cam Shaft
greenbook.PMD 4
IDLE R.P.M.
1300 - 1500 RPM
e. Cylinder Head i. Valve Seals
f. Rocker Arm j. Timing Chain
g. Valves k. Air Intake System
l. Ignition Coil, CDI, Magneto
3
m. Spark Plug
n. Exhaust System
8/28/2006, 2:24 PM