Assembly - Grizzly G0528 Owner's Manual

Assembly

To assemble the machine:
1.
Secure the rubber feet to the stand legs with
the four ⁄ "-20 x 1" phillips screws,
1
4
nuts, and ⁄ " flat washers (figure 6).
1
4
figure 6. rubber feet installation.
2.
arrange the front support, side supports, and
the "L" and "R" flange brackets in the order
shown in figures 7–8. be sure that the pivot
holes in the flange brackets are located at the
orientation shown in figure 7.
Flange bracket
Front Support
Side Support
figure 7. table support and bracket order.
3. Fasten the brackets together at both ends of
the front support (figure 8) with one
x 1" hex bolt, two
5
⁄ "-18 hex nut.
5
16
-14-
⁄ "-20 hex
1
4
pivot hole
⁄ "-18
5
16
⁄ " flat washers, and one
16
4.
using two ⁄ "-18 x 1
5
16
washers, and 5 ⁄ "-18 hex nuts, install the rub-
16
ber stops at the end of the flange brackets
(figure 8).
marked "L" marked "R"
Front Support
Side Support
rubber Stop
figure 8. table support assembly.
5. at the pivot bolt locations (figure 7), attach
the flange bracket to the table with two
x 1" hex bolts, six
⁄ "-18 lock nuts.
5
16
table
figure 9. table pivot installation.
model g0528 (mfg. 5/04+)
⁄ " cap screws, ⁄ " flat
1 5
2 16
Flange bracket
5 ⁄ "-18
16
⁄ " flat washers, and two
5
16
pivot bolt