Demonstration Mode - Sharp CD-MPS600W Operation Manual

! Setting the FM/AM span selector
The International Telecommunication Union (ITU) has established
that member countries should maintain either a 100 kHz or a 50 kHz
interval between broadcasting frequencies of FM stations and 10
kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz
zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear
panel) to the interval (span) of your area.
To change the tuning zone:
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
" For 50 kHz FM interval (9 kHz in AM)
" For 100 kHz FM interval (10 kHz in AM)
3 Whilst pressing down the button and the X-BASS/DEMO but-
ton, press the PRESET button until "CLEAR ALL" ap-
pears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.

! Demonstration mode

The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration
mode:
When the unit is in the power stand-
by mode (demonstration mode),
press the X-BASS/DEMO button.
The demonstration mode will be
cancelled and the display will disap-
pear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS/
DEMO button again.
Note:
When the power is on, the X-BASS/DEMO button can be used to se-
lect the extra bass mode.
! External FM aerial
Use an external FM aerial if you require better reception.
Consult your dealer.
50/9
100/10
Note:
When an external FM aerial is used, disconnect the supplied FM
aerial wire.
04/2/9
External
FM aerial
75 ohm
coaxial cable
CD-MPS800W(Z)E2.fm
TINSZA063AWZZ
CD-MPS600W
CD-MPS700W
CD-MPS800W
ENGLISH
4
E-13