Sharp CD-MPS600W Operation Manual page 35

! Recording from a CD or MP3 disc
You can record the desired disc using the DIRECT PLAY button.
1
Press the ON/STAND-BY button to turn the power on.
3
2
Press the CD button.
3
Load a cassette into the TAPE 2 cassette compartment
with side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
4
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
5
Press the button.
Recording will be paused.
6
Press one of the 1 -
7
Within 5 seconds, press the DIRECT PLAY button to start
recording.
" Recording starts from side A.
" Recording is started from the selected disc. When the play-
back of the last track is finished or the end of the tape is
reached, the disc and the cassette will stop automatically.
" Playback of the disc will start approximately 7 seconds after
the tape starts.
To stop recording:
Press the button.
The disc and tape will stop.
5 buttons to select the desired disc.
Sequential recording from several discs:
1 Perform steps 1 - 6 in "Recording from a CD or MP3 disc".
2 Within 5 seconds, press the / button to record on side A, or
the button for side B.
To perform programmed recording:
1 Programme discs and tracks (see pages 21, 25).
2 Press the button.
3 Press the / button to record on side A, or the
B.
To stop recording:
Press the button.
The disc and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
04/2/9 CD-MPS800W(Z)E4.fm
CD-MPS600W
CD-MPS700W
CD-MPS800W
ENGLISH
button for side
4
E-33
TINSZA063AWZZ