Sharp CD-DV777W Operation Manual page 13

Aerial connection
H
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS terminal and position the FM
aerial wire in the direction where the strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP socket. Position the AM loop
aerial for optimum reception. Place the AM loop aerial on a shelf, etc., or attach
it to a stand or a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause noise
pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling >
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
75 ohm
coaxial cable
Note:
When an external FM aerial is used, disconnect the supplied FM aerial wire.
*DV777W_EP09-14 10
H
Connect the black wire to the minus (-) terminal, and the red wire to the plus (+)
terminal.
Caution:
I Use speakers with an impedance of 6 ohms or more, as lower impedance
I Do not mistake the right and the left channels. The right speaker is the one
I Do not let the bare speaker wires touch each other.
I Do not stand or sit on the speakers. You may be injured.
< Attaching to the wall >
Wall Screws (not supplied)
External
FM aerial
Speaker connection
speakers can damage the unit.
on the right side when you face the unit.
Incorrect
12/4/04, 13:46
CD-DV777W (Z)
TINSZA083AWZZ
CD-DV777W
ENGLISH
4
E-10