Table of Contents
Advertisement
ESU04220
Control rod adjustment
The weight transfer can be adjusted by turning the con-
trol rod adjusting nut 1.
1. Loosen the locknut 2 while holding the control rod
adjusting nut.
2. Turn the adjusting nut in direction a to increase
weight transfer or direction b to decrease weight
transfer.
3. Tighten the locknut while holding the adjusting nut in
place.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
CAUTION :
@
G
When using the two wrenches included in the
owner's tool kit, make sure that they are situated
at a right angle to the control rod as shown, and
that they are tightly fitted to the locknut and the
control rod adjusting nut.
G
The left and right adjusting nuts must be set to
the same position. Uneven settings can cause
poor handling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c Adjustable range
d Standard position
8-21
Advertisement
Table of Contents
